![]() The main negative is that they recommend 502 glue (non-foam safe CA) for the assembly. It's all there, but unless you know what to look for, it could be challenging. ![]() Instructions are in fine print, both sides of one 8.5x11 inch paper. (Posted on ) First flight today Review by David Overall Overall - a great value and an excellent 3D trainer I heartily recommend the Hummer. Now I see that the recommendation is 20 - 40a. The landing gear attachment is one of the best I have seen on a foam model.Īfter just a few flights one of the servos failed. After several crashes I have only managed to break two props. The airframe has proven to be very strong. Maiden flight required only minor trimming. The model only required battery placement to achieve balance. This turned out to be a bad decision - more on this later. I purchased the recommended motor, ESC and servos. The included directions are of little help. Assembly was not too tough after viewing two vids on YouTube. The Hummer has certainly lived up to that desire. After destroying a pair of expensive models I decided to look for a more economical approach.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |